1.
Prepare
a solution of 30 parts warm tap water with 1 part liquid
detergent or baby shampoo.
2. Place
the sticky (non-linered) side of the tape lengthwise on the
shaft with approximately 1/4" tape extending over the end of
the shaft.
3.
Remove the paper release liner and smooth tape around shaft;
tuck excess tape into the shaft opening.
4. Pour
the water/soap solution into the grip, approximately 3/4
full, while blocking the small hole at the end so that
solution does not flow out.
5. Pour
the water/soap solution out of the grip and over the
tape-covered shaft. Be sure to moisten all of the tape,
spreading the solution by hand if necessary.
6. Place
the grip's opening onto the shaft and slide the grip all the
way into position on the shaft. Do not block the small hole
at the end of the grip. Make sure the grip is properly
aligned with the head of the golf club. Wipe off any excess
adhesive and water. The club will be ready for use within
four hours.
TRUST TEE
TIME GOLF PRODUCTS
100%
SATISFACTION GUARANTEED asi/342652
